9mm – ZHANGJIAGANG WINNER INDUSTRY CO.,LTD

Technical Specification: 9mm

Impact Resistance	5KJ/m2	Bending Strength	14 Mpa
Sound Insulation	42DB	Thermal Condctivity	0.153W/mk
Pull out strength	34N	Thickness Tolerance	±0.2mm
R-Value	0.082m2K/W	Weigtht per Sheet	31kg
Effects to Acid and Alkali	No Effect	Shrinkage/Swelling Rate	≤0.25%
Freeze-Thaw 100 Cycles	≥ 0.99	Chloride ion Content	<0.1%
Color	White/Gray	Thensile strength	1.6Nmm2

*Further sizes available on request
** Board Dimensions: 2440 x 1220 mm

Installation

1-Line Mark keel installation position

2-The top and floor keels are fixed along the line with expansion bolts, and the distance protection is 600-800mm

3-Knock the vertical keel in between the U-bar keels, and fix the vertical keel and U-bar keels using core rivets or keel clamps. The center distance of vertical keel is 611mm.

4-Install with cross tile keels for every 1221 mm in the horizontal direction.

5-Once the installation of the wall and the keel is completed, recheck the firmness and flatness, and fix it with wooden boards after confirming that it is qualified. Install from one side of the wall first.

A-2 sheets of panel are connected naturally.

B-A gap of 5mm must be reserved between the two panels to embed seam fillers. Also 3-5mm gaps for the top and bottom.

C- When the height of wall is over 3m, the vertical joints should installed staggered, 5mm away from the ceiling and floor.

D-Use our self-drilling screws to connect the board from its center to the adjacent fixed board. The distance protection is 15mm from the edge of the board, 50mm from the board, and 300mm from the fixed point. All screws should sink into the panel by 1-2mm.

6-After finishing the installation on one side, fill the keel with insulation materials, such as rock wool or aluminum silicate wool.

7-Use the same method to fix the panel on the other side.

8-Before joining the safety boards, it is necessary to paste about 5 to 8 cm of primer on the 4 sides of the panel, especially in hot weather. After the joint material is dry, cover the joint with a waterproof primer. It is recommended to use hydraulic cement-based gap filler or other flexible types instead of gypsum-based filler.

The environmental requirements of joint filler should comply with the instructions. It is recommended to use self-adhesive mesh tape and drywall tape.

Material And Chemical Safety Data Sheet

Hazard Identification and First Aid Measures

These boards are classified as non-hazardous substances. Dust may cause irritation to the nose, throat, and respiratory tract, causing coughing and sneezing. Skin contact may cause irritation, but it will not be absorbed by the skin.

Swallowed or Inhaled

If swallowed, drink plenty of water to dilute. Move to a place with fresh air.

Eye Contact

Wash the affected area with clean water or saline solution for fifteen minutes.

Personal Protection

When handling the boards that may generate dust, follow practices to restrain the release. Work outdoors wherever possible and wear dust masks to reduce exposure. Wear safety goggles/glasses and gloves when cutting. Direct contact with the skin should be avoided.

The boards are not classified as a hazardous substance and contain NO FORMALDEHYDE or

ASBESTOS. No special provision is required regarding carriage and disposal of the boards.

IF ANY ADVERSE SYMPTOMS PERSIST, SEEK MEDICAL ADVICE.